Unitech MS920 Uživatelský manuál stáhnout pdf (Strana 96)

- 90 -

Tolerance

- The tolerance level for center decoding allows you to aim the laser close to

the bar code to be read rather than be positioned on the bar code.

- 0 = No tolerance (laser aimer must be positioned on the bar code to be read),

100 = most permissive (laser aimer can be positioned beside the bar code to

be read).

No tolerance (*)

Compose (%):

Bar code sequence

- Bar code sequence allows you to read up to 10 bar codes with one trigger

pull. This is useful when reading several bar codes placed closely together

and without re-reading the same code twice.

- For example, if set to 2, pull the trigger once and scan both codes. The

scanner beeps for each code that is decoded (2). If "turn off after good read"

is enabled the scanner turns off AFTER the last bar code in the sequence is

read.

- Compose the number of bar codes for the sequence.

1 (*)

Compose: Please refer to SCM (Software Conguration Manager) in CD

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 117 118

Žádné komentáře

Unitech MS920 Uživatelský manuál Strana 96