Unitech MS350 Uživatelský manuál stáhnout pdf (Strana 121)

121

String setting / Transmission

(Insert Group Characters)

Insert G1/G2/G3/G4 character setting: The imager

supports inserting two groups with each group 22 characters

into transmitted data of selected symbologies. The two

groups can be inserted into scanned data of the selected

symbologies or positioned at leading / ending of data. There

are total four groups for utilization.

Insert data group position: To define the position of a group

to insert into bar code data. Please notice that the inserting

position of a group must not exceed the code length; or the

insertion will be positioned at the ending of data.

Notice: Default value “00” indicates the group to be

positioned at the leading of data. “64” represents for

positioning the group at the ending of data.

Insert data group setting procedure:

i. Define the characters of groups for insertion.

ii. Setup the inserting position of each group in

scanned data.

iii. Select one or two groups to insert into specific

bar codes. Please refer to the setting pages of

each bar code.

Example: Barcode “1 2 3 4 5 6”.

Output- Barcode “1 2 A B 3 4 C D 5 6”.

Steps:

1) Scan Programming and Insert G1 characters setting

barcode.

2) Use the ASCII code table to find the value of A ?41,B? 42.

3) Scan 4, 1 and 4, 2 from the barcode on the fold out back

page.

4) Scan Finish from the barcode on the fold out page.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 132 133

Žádné komentáře

Unitech MS350 Uživatelský manuál Strana 121