Unitech PA500 Uživatelský manuál stáhnout pdf (Strana 11)

Chapter 1 Getting Started

Setting up the PA500

Perform the following set up tasks to begin using your device:

• Install the battery pack

• Charge your device

• Power on the PA500

Installing the Battery

WARNING! There is a risk of fire and burns if the battery pack is handled

improperly. DO NOT disassemble, crush, puncture, short external

contacts, or dispose the battery pack in fire or water. DO NOT attempt

to open or service the battery pack. Dispose of used batteries

according to the local recycling guidelines in your area.

A backup battery cell is embedded into your device to prevent data loss when the removable battery

pack is removed or completely discharged. The backup battery will keep the data and system settings up

to 1 hour if the main battery is removed.

NOTE: To enable the internal battery cell to provide backup power supply, charge your device

with the main battery pack for at least three and a half hours.

1. Position the battery pack, making sure the battery pack fits the shape of the battery

compartment.

2. Slide the battery pack into the battery bay. The battery pack locks to the chassis with an audible

click.

3. If you remove the main battery and plug it back before the backup battery lost

power, PA500 will be warm start.

4. If you remove the main battery and plug it back after the backup battery lost power,

PA500 will be clean booted.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 83 84

Žádné komentáře

Unitech PA500 Uživatelský manuál Strana 11